Engl Steve Morse Signature 100 Manuel de l'opérateur télécharger pdf (Page 17)

you flip the Standby switch because the tubes are already warm and don't require time

to heat up. For breaks of 30 minutes and longer, I recommend that you switch the amp

off in order to conserve energy.

Mains power on/off.

At the back of the manual you'll find a folded page offering diagrams of the front and

rear panels. Please unfold and refer to it as you read through the descriptions of

features and functions!

Plug the mains cord in here. For European models, use a standard non-heating

equipment connector cable.

Make sure you use an intact mains line cord with a grounded plug! Before

you power the amp up, ensure the voltage value printed alongside the mains port is

the same as the current of the local power supply or wall outlet.

Please also heed the guidelines set forth in the separately included pamphlet,

The rear chamber contains the mains fuse and the front chamber a spare fuse.

This switch severs the circuit connecting the amp's internal ground to the wall

receptacle's ground terminal. You can set the switch to when you

have connected a signal processor or power amp and want to prevent the two devices'

grounds from forming a ground loop that manifests in annoying humming.

A ground loop is an extraordinary condition. Under ordinary

circumstances, ensure the button is set to to earth the amp to the mains

ground, thereby preventing ungrounded line noise!

This 5-pin DIN port patches incoming MIDI data from the (43) to any other

connected MIDI device.

This 5-pin DIN port accepts data sent by a MIDI sender (for example, the ENGL MIDI

Z-12, Z-15, or Z-9 foot controllers) or from or routed through another MIDI device.

38 Power

Mains Connector (

40 Mains Fuse Box:

41 Ground Lift Switch

42 Midi Thru

43 Midi In

Rear Panel Features

CAUTION:

CAUTION ALWAYS make sure replacement fuses are of the same type and have the

same ratings as the original fuse! To this end, please refer to the fuse ratings shown

on the type panel.

Please note:

Instructions for the Prevention of Fire, Electrical Shock and Injury

Ground Floated

Ground

MIDI In

39 AC Power Inlet; IEC - C14 connector)

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 36 37

Pas de commentaire

Engl Steve Morse Signature 100 Manuel de l'opérateur Page 17