Engl Steve Morse Signature 100 Manuel de l'opérateur télécharger pdf (Page 13)

equation and you end up with amazing tonal flexibility. You'll like having sounds of

such diversity and quality at your disposal. And you'll love being able to access such a

broad spectrum so easily on stage.

This is the preamp voicing section's passive high-frequency EQ for 3.

To help you get acquainted with the amp's fundamental sounds, I recommend that

you set all tone controls to about the center or 12 o'clock position. For higher-gain,

high-volume lead sounds, your best bet is to turn the Treble knob down to prevent the

pickups and speakers from generating feedback (a setting in the 9-to-1 o'clock range is

recommended).

Each channel is equipped with a dedicated EQ so you can tweak its sound separately to

suit your taste and the given sonic scenario. Bear in mind that you also have the two

power amp (14) and (15) knobs at your disposal for shaping the

frequency range.

Though this passive voicing section's controls range is narrower than that of a

comparable active system, its EQ curve is tweaked specifically for its designated

purpose, and will give you satisfying results.

This volume knob sets the level of preamp Channel 3 when Lo Gain mode is activated.

Use this knob to adjust the volume of Channel 3 in Lo Gain mode and balance levels

with the other channels as well as with Channel 3's Hi Gain mode. This knob sits in front

of the effects loops, so it also sets the level of both effects outputs when Channel 3 is

active. The red LED to the right of the knob lights up to indicate Channel 3 Lo Gain

mode is activated.

This volume knob sets the level of preamp Channel 3 when Hi Gain mode is activated.

Use this knob to adjust the volume of Channel 3 in Hi Gain mode and balance levels

with the other channels as well as with Channel 3's Lo Gain mode. This knob sits in front

of the effects loops, so it also sets the level of both effects outputs when Channel 3 is

active. The red LED to the right of the knob lights up to indicate Channel 3 Hi Gain

mode is activated.

Master A volume knob. Located post effect loops, it controls power amp output. The

red LED to the right of the knob lights up to indicate is enabled and

determining the master level. You can also set the master level to 0 ( via

Channel

Presence Depth Punch

Master A

Amp Mute)

A tip from the designer:

29 Lo Volume 3

30 Hi Volume 3

28 Treble

31 CH 3

32 Master A

Press this button to activate preamp Channel 3 directly. The red LED to the right of the

Channel 3 Volume knobs (29 or 30) lights up to indicate Channel 3 is active. Channel 3

may also be activated via MIDI program change, the ENGL Custom Z-9 Footswitch, or a

dual footswitch.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 36 37

Commentaires sur ces manuels

Pas de commentaire

Engl Steve Morse Signature 100 Manuel de l'opérateur Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Amplificateurs audio Engl Steve Morse Signature 100